Three Phase Soft-Starter

4/14 Ralph Black Drive

Wollongong 2500

NSW Australia

To contact us:

Phone: +61 2 4229 2069

Fax: +61 2 4229 2069

E-mail:john@hypereng.com

Dimensions

Not including mounting bracket which will add 6mm to the height and 5mm to the width.

 

                 HYPER ENGINEERING is not to be held responsible for erroneous literature regarding capacities, dimensions, applications, etc. stated herein. Products, specifications and data in this literature are subject to change without notice. The information herein is intended only for use by persons having the appropriate technical knowledge and skills, at their own discretion and risk. Since conditions of use are outside of HYPER ENGINEERING’S control we cannot assume any liability for results obtained or damages occurred due to improper application.

This model Sure-Start  functions as a Three Phase softstarter and connects between the contactor and the motor. While it does reduce  the starting current and provide compressor reverse rotation protection, its main function is to provide a more controlled start to limit the mechanical noise and shock of a three phase DOL start.

The softstarter is designed to learn the motor characteristics of the load. After a few starts it will have automatically adjusted itself to the load and the electrical supply impedance at the site.

ABN: 62003 608188

Voltage   

Frequency

Maximum Cont. Current

Dimensions

Material

IP Rating

Software Fault Delay

Software Optimization

Phase Rotation Detection

Duty Cycle

Initial Power on Delay

Shutdown on Low Voltage

Power Loss Reset

415 volts AC

50Hz

25 amps rms

135mm x 75mm x 50mm high

ABS Flameproof. UL-94VO

IP217 (IP547 on request)

300 seconds

Compensates for Motor Size

Lock out for reverse phase sequence

15 starts / hour

2 seconds

Less then 195 volts to neutral

150mS detection

Three Phase Soft-Starter Specifications